Pool Cove Kit

Make your swimming pool liner installation easy with Styrofoam cove kits. Freight for this item will be an extra charge.  This item is exempt from free shipping unless you are ordering a pool kit

Pool Cove
Playtime Peel N’ Place Pool Cove is designed to be installed in minutes with minimal effort.  It will last for the life of your pool liner.  Pool cove will save time during installation and will assure you that you have the correct size cove to extend the life of your liner
Store your pool cove in a constant cool temperature until you are ready to install.  If the cove is too hot when installed the cold water could cause the cove to contract and leave gaps between pieces.

1. Follow all of the pools manufactures instructions that precede the cove installation.
2. Clear a 4inch wide level surface around the entire inside of the pool wall.  Be sure that the bottom 6” of the pool wall is clean and dry
3. Install the first piece by peeling the protective backing of the adhesive strip on the back of the pool cove.  Expose about half of the adhesive strip
4. Press the adhesive backing on the first piece of pool cove against the wall.  Remove the remainder of the protective backing and press the rest of the cove into place along the bottom of the pool wall
5. Continue around the remainder of the pool wall installing successive pieces of cove.  Press each piece tightly against the end of the piece that was already installed.  Make sure there are no gaps or cracks left between sections.  Do not install the las piece of cove
6. Before installing the last piece of cove, check to see that all pieces fit firmly against each other and rest on the ground around the pool wall
7. Cut the last piece of cove to fit tightly in the remaining space.  Insert the final piece,
8. Continue setting up your pool.

For smaller diameter pools Spray adhesive is recommended .  Best to use on 10ft, 12ft, 12x18ft and 12x24ft pools